EN 50083-9 PDF

DIN EN Cable networks for television signals, sound signals and interactive services – Part 9: Interfaces for CATV/SMATV headends. Buy CEI EN CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES – PART 9: INTERFACES FOR . BS EN Cable networks for television signals, sound signals and interactive services – Interfaces for CATV/SMATV headends and similar.

Author: Bradal Nam
Country: Cambodia
Language: English (Spanish)
Genre: Medical
Published (Last): 4 November 2004
Pages: 432
PDF File Size: 19.57 Mb
ePub File Size: 10.50 Mb
ISBN: 825-8-15661-838-5
Downloads: 11902
Price: Free* [*Free Regsitration Required]
Uploader: Akinokasa

You may find similar items within these categories by 5008-9 from the choices below:. It’s a community-based project which helps to repair anything. The line driver and receiver shall be 50038-9, i. Switching between the code words depending on the RD in the 50083-9 and receiver maintains the DC balance. Once found, the start of the synchronization word marks the boundary of subsequent received data words and establishes proper byte-alignment of decoder output bytes.

The faster, easier way to work with standards. Byte synchronization The byte alignment synchronization pattern shall be the K Both the buffer underflow and the relatively large buffer size should be avoided in practical situations. The first byte received after the second K All kinds of networks like: On the ASI link, the bytes can be displaced in time with respect to their isochronous position. An example is shown in Figure F. The average data rate in bytes per second is then given by the formula: The masks allow for HF jitter present in the 5008-39 signal associated with the source of interface signal When using an oscilloscope technique to determine pulse compliance with the mask, it is important that successive traces of the pulses overlay in order to suppress the effects of low frequency jitter.

  EV 350R PDF

Your basket is empty.

EVS-EN 50083-9:2002

Optical measurements shall be made with the cable terminated with the optical connector and the optical fibre specified above. Find Similar Items This product falls into the following categories.

Subscription pricing is determined by: Worldwide Standards We can source any standard from anywhere in the world. The highest rate then fills the receiver buffer more rapidly than the average rate at which data is 50803-9 from the buffer.

SSI is synchronous to the Transport Stream which is transmitted on the serial link. Physical requirements The physical layer defines the transmission media, the drivers and receivers, and the transmission speeds.

BS EN 50083-9:2002

In some cases, an ASI output may work with an ASI input with a smaller buffer than is specified for the output, however ASI interoperability under these circumstances cannot be guaranteed. ATM is particularly suitable for providing bandwidth on demand and it allows for high data rates. RD at the end of any sub-block is negative, if the sub-block contains more zeros than ones, or if the subblock is or 500839- violations may result from a prior error which altered the RD of the bit stream, causing a detectable error at the current transmission character.

Maximum common mode signal: Interfaces pour les tetes de resaux pour antennes communautaires, antennes collectives par satellite et materiels professionnels a Title in German Kabelnetze fuer Fernsehsignale, Tonsignale und interaktive Dienste. This clock can be multiplied up by to generate a bit rate clock. The attenuation of the f law. These normative references ej cited at the appropriate places in the text and the publications are listed hereafter.

  HIMARK RX3310A PDF

Indicates the beginning of a Transport Packet by signalling the sync byte. Packet synchronization At least two synchronization code words K In order to recover byte alignment, a decoder searches in the serial stream eh the synchronization word which is necessary to achieve the serial to parallel conversion.

The Amber document status indicator indicates that some caution is needed when using this document – it is either: NOTE In order to prevent possible synchronisation errors, it is recommended that consecutive bytes 47H do not occur within the byte or byte data packet.

Data are read from this buffer at rn constant rate determined by the transmission clock tx-clk.

EVS-EN – Estonian Centre for Standardisation

The masks allow for HF jitter caused by intersymbol interference in the output stage, but not for jitter present in the timing signal associated with the source of the interface signal. This is intentional as it leaves maximum implementation flexibility for different applications.

Reseaux de distribution par cables destines aux signaux de radiodiffusion sonore, de television et aux services interactifs. By phase locking to the sync byte arrival, a packet clock and a bit clock can be derived. With the signal then applied, the vertical position of the trace can be adjusted with the objective of meeting the limits of eh masks. These sync words are to be ignored by receive equipment. As the voice of the U.