December CDBMS. CMOS Low-Power Monostable/Astable Multivibrator. DATASHEET. Features. • High Voltage Type (20V Rating). CD Datasheet, CD Monostable/astable Multivibrator Datasheet, buy CD Data sheet acquired from Harris Semiconductor. SCHSA – Revised March The CDB-Series types are supplied in. lead hermetic dual-in-line.

Author: Kajikree Shaktirn
Country: Montserrat
Language: English (Spanish)
Genre: Medical
Published (Last): 25 January 2004
Pages: 482
PDF File Size: 13.75 Mb
ePub File Size: 16.92 Mb
ISBN: 429-2-36928-292-8
Downloads: 72293
Price: Free* [*Free Regsitration Required]
Uploader: Brahn

Submitted by admin on 21 February Would you be able to show me how to connect it? I am not sure how to connect each other.


Message 4 of The IC can be used for generating clock pulse, sine wave, square wave and many others. Yeah i having trouble connecting CD to use it as CD as shown in the picture. Message 5 of Here, the circuit is given below for Multivibrator in Astable mode:. So this is probably use less at this point, but in the most recent version of Multisim It can also be used in application of datasheer delay circuits, frequency multiplier and frequency divider. Cd40477 formula for finding the value of frequency mathematically at PIN 11 and 10 is: So were you able to find the workaround afterwards?


Hope that you could find this helpful! It needs an external resistor to be connected between PIN 1 and 3 to determine the output pulse width in Monostable mode.

CD Datasheet(PDF) – Fairchild Semiconductor

Message 9 of Like I mentioned, I was having trouble with CD and seems the pinout in the multisim is quiet different with the datasheet for the CD and CD This is the diagram that I was working on. Thank datasneet for the suggestions.

Message 6 of Message 7 of TL — Programmable Reference Voltage.

Here, the circuit is given below for Multivibrator in Astable mode: For determining Output cc4047 in Astable mode it needs a capacitor to be connected between PIN 2 and 3. We can use the IC in both Astable and Monostable mode, for making different circuit. How to use IC?

CD4047 Monostable/astable Multivibrator

It seems the pinout layout for the CD in the multisim is quiet different than the datasgeet CD I cannot see the attachment. If you found that they can be used as a sustitute I would think that there schematic should be very similar to get the response that you want, but the confirmation of the wiring is somehting that you can get from the devices datasheet.


The circuit is given below to use the IC in Monostable mode: Message 1 of Are you trying to connect the CD using the diagram for the CD? Pin Configuration Pin No. Can you elaborate a little bit more on your post?

Multisim and Ultiboard

Message 3 of Thank you for uploading the circuit, I have opened and compared it with the ones I found online for the CD, and they look pretty much the same, so should I assume that you have already looked at the datasheets of both components to determine if the pinout is the same? Which is the picture that you are using and what are the results that you are getting with it?

I am glad to see that you found the documets helpful! Message 2 of CD was used because it was comparable with CDs.

The formula for finding the value of oscillated output frequency from PIN 13 mathematically is: Message 10 of To generate an envelope signal from the original signal this IC is helpful.